孔柏岭,昌润珍,海玉芝,李晓玲,白周凌
KONG Bai-ling~1,CANG Run-zhen~1,HAI Yu-zhi~1,LI Xiao-ling~1,BAI Zhou-ling~2 (1.Research Institute of Exploration and Development of Henan Oilfield Company of SINOPEC

• 1:中国石化河南油田分公司石油勘探开发研究院
• 2:中国石化河南油田分公司第一采油厂

摘要(Abstract)：

微凝胶驱技术(低浓度交联聚合物驱技术)是一项低成本高效益的提高采收率新技术。河南油田在室内研究基础上,系统地开展了微凝胶驱技术的单井试注、单井驱替、多井组驱替等不同规模的矿场试验,展示出明显不同于聚合物驱的动态特征:注入压力上升幅度大,吸水剖面改善幅度比聚合物驱好,产出液聚合物浓度低,见效时间滞后。下二门H_2Ⅲ油组、双河437Ⅱ_(1-2)油组矿场试验注污水配制微凝胶(400 mg/L HPAM、60 mg/L Cr~(3+))0.19～0.37 PV,当量吨聚合物增油85.2～105.3 t,阶段提高采收率6.01%～7.17%;提高采收率幅度比聚合物驱高2.96个百分点的条件下,化学剂费用降低11.4%～19.9%。矿场试验结果还表明,微凝胶驱技术与聚合物驱技术结合使用,可以取得更好的驱油效果。
Microgel flooding technique(low-concentration cross-linked polymer flooding) is one of low-cost and higheffect (high input-output ratio) enhancing oil recovery techniques.On the basis of indoor studies on this technique,different -size field tests of single-well test injection,single-well flooding,multiple-well groups flooding and so on have systematically caught out in Henan Oilfield.All the performances are quite different from the dynamic characteristics of polymer flooding:bigger rising degree of injection pressure,much better improved degree of water-absorption cross section, lower produced water concentration,later response time and so forth.0.19—0.37 PV microgel solution(HPAM: 400mg/L,Cr~(3+):60mg/L) prepared by produced oilfield water has injected into Xia' ermen No.H_2Ⅲand Shuanghe No.437Ⅱ_(1-2) oil reservoir groups of the pilot,finally results in incremental equivalent oil 85.2—105.3t per ton of polymer, enhanced stage oil recovery 6.01%—7.17%and increased oil recovery degree 2.96%higher than the one of polymer flooding but the chemicals' cost has reduced 11.4%—19.9%.The field test results show that the combination of microgel and polymer flooding techniques can obtain much better oil flooded results and furthermore the study thoughts of the above two techniques'combination have been caught out in the end.

关键词(KeyWords)： 微凝胶驱技术;矿场试验;动态特征;聚合物驱技术;组合驱技术
microgel flooding technique;field test;dynamic characteristic;polymer flooding technique;combined flooding technique

Abstract:

Keywords:

基金项目(Foundation): 中国石油化工股份有限公司科技攻关项目“聚合物交联微凝胶体系驱油技术”(P99031)部分成果

作者(Author): 孔柏岭,昌润珍,海玉芝,李晓玲,白周凌
KONG Bai-ling~1,CANG Run-zhen~1,HAI Yu-zhi~1,LI Xiao-ling~1,BAI Zhou-ling~2 (1.Research Institute of Exploration and Development of Henan Oilfield Company of SINOPEC

参考文献(References)：

• [1]王德民.发展三次采油新理论新技术,确保大庆油田持续稳定发展[J].大庆石油地质与开发,2001,20(3):1-7.
• [2]牛金刚.大庆油田聚合物驱提高采收率技术的实践与认识[J].大庆石油地质与开发,2004,23(5):91-93.
• [3]廖广志,牛金刚,邵振波,等.大庆油田工业化聚合物驱效果及主要做法[J].大庆石油地质与开发,2004,23(1):48-51.
• [4]He Jinsong.High Temperature Polymer Flooding in Thick Reservoir in Shuanghe Oilfield[R].SPE50933,1998:533-542.
• [5]樊中海,吕连海.河南油田聚合物驱矿场实践及经济效益浅析[J].河南石油,1999,13(6):1-6.
• [6]Alain Zaitoun.Limiting Conditions for the Hydrolyzed Polyacrylamide in Brines Containing Divalent Ions[R].SPE11785,1983:143- 150.
• [7]Ahmad Moradi-Araghi.Stability of Polyacrylamides in Hard Brines at Elevated Temperature[R].SPE13033,1984:1-12.
• [8]孔柏岭,罗九明.高温油藏条件下聚丙烯酰胺水解反应研究[J].石油勘探与开发,1998,25(6):67-69.
• [9]孔柏岭,宋振宇.耐温抗盐的低浓度交联聚合物体系研究[J].石油学报,2000,2l(4):70-74.
• [10]孔柏岭,韩杰.聚丙稀酰胺的分子结构对微凝胶体系性能的影响[J].石油勘探与开发,2001,28(5):71-74.
• [11]皇海权,唐金星.微凝胶渗流特性参数研究[J].河南石油, 2004,18(2):35-38.
• [12]吕晓华,唐金星.低浓度微凝胶体系动态成胶及驱油试验[J].石油与天然气化工,2003,32(3):162-169.
• [13]Han Dong.Flow Mechanism of Investigation and Field Practice for Low Concentration Flowing Gel[R].SPE50929,1998:483-500.
• [14]樊中海,孔柏岭.微凝胶驱技术在下二门油田的应用[J].石油勘探与开发,2004,31(1):110-112.