王小兵,刘阳,李森,李景波,吕雷纲,龚浩宇,王多琦,杜明智
WANG Xiaobing,LIU Yang,LI Sen,LI Jingbo,Lü Leigang,GONG Haoyu,WANG Duoqi,DU Mingzhi

• 1:常州大学石油工程学院
• 2:中国石油辽河油田分公司钻采工艺研究院

摘要(Abstract)：

在高凝油油田开发过程中,采用空心抽油杆热水循环工艺的伴热方式可有效提高油田稠油开采效率。针对空心抽油杆热水循环加热工艺,通过流体流动特性和地层物质间传热特性建立数学模型,利用多物理场耦合的有限元计算方法,选取含水率、连续管内径和注入水工作参数,以平均降黏率为衡量指标,对该工艺的降黏效果进行研究。结果表明:计算结果与现场实测数据的误差小于5%,可靠性高;该工艺在含水率相对较低的油井中具有更好的降黏效果,采用较细连续管可有效提高工艺降黏效率;与增加注水量相比,增加注水温度具有更佳的技术经济效果。
In the process of high-condensate oilfield development, the heat tracing method of hollow-sucker-rod hot-water circulation technology can effectively improve the efficiency of heavy oil exploitation in the oil field. Aiming at the hot-water-circulation heating process of hollow sucker rods, the mathematical model was established by the fluid flow characteristics and heat transfer characteristics among the formation materials, and the finite-element calculating method of the multiphysical field coupling was used to select the water cut, continuous-tube inner diameter and injection water operating parameters. The viscosity reduced effect of the technology was studied by measuring the average viscosity reduced rate. The results show that the error between the calculated result and the field measured data is less than 5%,so the reliability is pretty high. The technology has better viscosity reduced effect in the oil well with relatively low water cut, and the thinner inner tube diameter can effectively improve the viscosity reduced efficiency. Comparing with increasing the water injection, increasing the injected water temperature has much better technical and economic effects.

关键词(KeyWords)： 稠油;热水循环;数值计算;含水率;降黏率;注水温度
heavy oil;hot water circulation;numeral calculation;water cut;viscosity reduced rate;injection temperature

Abstract:

Keywords:

基金项目(Foundation): 国家自然科学基金项目“过饱和蒸汽非平衡态等离子体诱导凝结过程机理研究”(51706023)

作者(Author): 王小兵,刘阳,李森,李景波,吕雷纲,龚浩宇,王多琦,杜明智
WANG Xiaobing,LIU Yang,LI Sen,LI Jingbo,Lü Leigang,GONG Haoyu,WANG Duoqi,DU Mingzhi

DOI: 10.19597/j.issn.1000-3754.201904041

参考文献(References)：

• [1]张勇,李小刚,张德彬,等.双空心杆闭式循环加热工艺[J].油气田地面工程,2011,30(2):55-56.ZHANG Yong,LI Xiaogang,ZHANG Debin,et al.Closed circle heating process for double hollow pumping rod[J].Oil-Gas Filed Surface Engineering,2011,30(2):55-56.
• [2]陈涛平,高雪,王玉国,等.稠油高凝油抽油机井拌热工况优化[J].特种油气藏,2013,20(3):132-136.CHEN Taoping,GAO Xue,WANG Yuguo,et al.Optimization of hot mixing conditions for heavy oil high-condensation oil pumping unit[J].Special Oil & Gas Reservoirs,2013,20(3):132-136.
• [3]付亚荣.同轴式双空心抽油杆下入深度设计方法[J].石油钻探技术,2012,40(4):107-110.FU Yarong.Determination method for the landing depth of coaxial dual hollow rod[J].Petroleum Drilling Technique,2012,40(4):107-110.
• [4]刘广天,单学军.稠油热采井井筒温度模型研究及应用[J].科学技术与工程,2014,14(22):189-192.LIU Guangtian,SHAN Xuejun.Wellbore temperature model study and application in heavy oil thermal recovery well[J].Science Technology and Engineering,2014,14(22):189-192.
• [5]牛彩云,周志平,常莉静,等.空心杆热洗清蜡工具的改进与应用[J].钻采工艺,2019,42(1):106-107.NIU Caiyun,ZHOU Zhiping,CHANG Lijing,et al.Improvement and application of hollow rod hot wash wax removal tool[J].Drilling & Production Technology,2019,42(1):106-107.
• [6]SONG Guangshou,ZHOU Tiyao,CHENG Linsong,et al.Aquathermolysis of conventional heavy oil with superheated steam[J].Petroleum Science,2009,6(3):289-293.
• [7]张子刚.双空心杆循环伴热技术在超稠油井上的应用[J].石油石化节能,2014,4(2):17-18.ZHANG Zigang.Application of double hollow rod cycle tracing technology in super-heavy oil wells[J].Energy Conservation in Petroleum & Petrochemical Industry,2014,4(2):17-18.
• [8]张建,羊争鸣.空心抽油杆井筒热流体循环数值模拟研究[J].石油钻采工艺,1991,13(1):51-58.ZHANG Jian,YANG Zhengming.Numerical simulation of thermal fluid circulation in hollow sucker rod well[J].Oil Drilling & Production Technology,1991,13(1):51-58.
• [9]卢祥国,李文甫.空心抽油杆掺热水时杆及井筒温度分布研究[J].大庆石油学院学报,1993,17(1):36-43.LU Xiangguo,LI Wenfu.Research on temperature distribution of rod and wellbore in hollow sucker rods with hot water[J].Journal of Daqing Petroleum Institute,1993,17(1):36-43.
• [10]梁金国,任瑛,王弥康,等.空心抽油杆开式热水循环采油工艺理论分析[J].石油大学学报(自然科学版),1993,17(1):56-61.LIANG Jinguo,REN Ying,WANG Mikang,et al.Theoretical analysis of open hot water circulation oil recovery technology for hollow sucker rods[J].Journal of the University of Petroleum(Edition of Natural Science),1993,17(1):56-61.
• [11]王丽娜,崔金榜,李金永,等.双空心抽油杆内循环技术[J].油气田地面工程,2010,29(2):88-89.WANG Lina,CUI Jinbang,LI Jinyong,et al.Internal circulation technology of double hollow sucker rods[J].Oil-Gas Filed Surface Engineering,2010,29(2):88-89.
• [12]林日亿,梁金国,杨德伟,等.空心抽油杆内密闭热水循环降黏技术[J].中国石油大学学报(自然科学版),2010,34(3):104-108.LIN Riyi,LIANG Jinguo,YANG Dewei,et al.Viscosity reduction technology by closed hot water circulation in hollow sucker rod [J].Journal of China University of Petroleum(Edition of Natural Science),2010,34(3):104-108.
• [13] RAMEY H J.Wellbore heat transmission[J].Journal of Petroleum Technology,1962,14(4):427-435.
• [14]康志勇,张勇.辽河油区计算稠油粘度通用方程[J].特种油气藏,2005,12(6):101-102.KANG Zhiyong,ZHANG Yong.General expression of heavy oil viscosity[J].Special Oil & Gas Reservoirs,2005,12(6):101-102.
• [15] 史维秀,李惟毅,潘利生,等.空心杆泵上循环热水加热降黏的数值研究[J].机械工程学报,2011,47(2):154-158.SHI Weixiu,LI Weiyi,PAN Lisheng,et al.Numerical study on heating and viscosity reduction of circulating hot water in hollow rod top pump[J].Journal of Mechanical Engineering,2011,47(2):154-158.
• [16] 曹畅,罗君兰,刘磊,等.超深稠油注天然气气举降掺稀先导试验[J].大庆石油地质与开发,2019,38(1):116-120.CAO Chang,LUO Junlan,LIU Lei,et al.Pilot test of the viscosity reduction by the natural gas injection and lift for the extra-deep heavy oil[J].Petroleum Geology & Oilfield Development in Daqing,2019,38(1):116-120.
• [17] 周洪亮.油管电加热技术优化研究[J].大庆石油地质与开发,2013,32(2):154-158.ZHOU Hongliang.Optimization study on electric heating technique by oil tube[J].Petroleum Geology & Oilfield Development in Daqing,2013,32(2):154-158.
• [18] 曲占庆,张琪,陈德春,等.空心杆掺稀油深层稠油举升设计方法研究[J].石油大学学报(自然科学版),2000,24(5):63-64.QU Zhanqing,ZHANG Qi,CHEN Dechun,et al.Design method for lifting heavy oil by mixing light hydrocarbon in hollow rod[J].Journal of the University of Petroleum(Edition of Natural Science),2000,24(5):63-64.
• [19] 杜建波,熊友明,马帅,等.刚果深水稠油井井筒电缆加热降黏工艺[J].大庆石油地质与开发,2014,33(2):106-110.DU Jianbo,XIONG Youming,MA Shuai,et al.Wellbore electric heating-visbreaking technology for Congo deepwater heavy oilfield[J].Petroleum Geology & Oilfield Development in Daqing,2014,33(2):106-110.
• [20] 王国锋.稠油井油管电加热间歇加热制度优化[J].大庆石油地质与开发,2018,37(3):96-100.WANG Guofeng.Optimization of intermittent heating system for electric heating of heavy oil well tubing[J].Petroleum Geology & Oilfield Development in Daqing,2018,37(3):96-100.
• [21] 魏世俊.“管中管”密闭式热水循环降粘工艺技术浅析[J].内蒙古石油化工,2013,39(2):109-110.WEI Shijun.Analysis on the technology of closed-type hot water circulation viscosity reduction in “tube-in-tube”[J].Inner Mongolia Petrochemical Industry,2013,39(2):109-110.
• [22] 王晓璇,雷毅,刘更民.稠油降黏技术应用研究[J].中国石油大学胜利学院学报,2012,26(2):27-30.WANG Xiaoxuan,LEI Yi,LIU Gengmin.Application research of viscosity reduction technology for heavy oil[J].Journal of Shengli College China University of Petroleum,2012,26(2):27-30.
• [23] 杨俊科,张荣甫.双空心杆闭式循环技术在稠油井的应用[J].石油矿场机械,2015,44(11):90-93.YANG Junke,ZHANG Rongfu.Application of double hollow rod closed-cycle technology in heavy oil wells[J].Oil Field Equipment,2015,44(11):90-93.