李俊
LI Jun

• 1:大庆油田有限责任公司第六采油厂

摘要(Abstract)：

针对聚合物驱存在厚油层顶部或各韵律段顶部的中低渗透油层动用差、聚驱效果差、层间矛盾更加突出等问题,为进一步提高中低渗透油层的驱油效率,利用天然气具有在地层中自然膨胀效应和重力分异作用,更容易进入中低渗透率油层的特点,开展了天然气与聚合物交替驱油室内研究。通过岩心驱油实验,研究了气体段塞大小、气液比、聚合物相对分子质量、聚合物溶液质量浓度、段塞组合等对天然气与聚合物交替驱油提高采收率效果的影响。注入参数优化实验结果表明,天然气与聚合物交替驱油比聚合物驱多提高采收率11%;交替周期、聚合物相对分子质量和前置段塞等对提高油层存气率和气体突破速度的影响实验表明,缩短交替周期,利用中分子聚合物交替并增加高浓度聚合物前置段塞,可有效减缓气窜。
In the light of the problems such as the poorer development of low and medium permeability oil layers,poorer polymer oil-driving effects,rather serious and obvious interlayer contradiction and so on for the polymer driving on the top of thick or each rhythmic interval,in order to enhance the oil flooding efficiency of these reservoirs and intervals,by means of the expansion effects and gravitational differentiation of the natural gas in the reservoirs and furthermore the superiority of the gas more easier penetrating into these layers,the indoor natural alternating polymer oil-flooding experiment is conducted.With the help of the core oil-displacing experiment,the influences are studied for the gas slug size,vapor-liquid ratio,the relative molecular weight/mass and solution concentration of the polymer,slug combination and so forth on the effects of enhancing the oil flooding.The experimental results of the injection parameter optimization show that comparing with the polymer driving;the additional recovery factor of the alternate flooding can reach 11%;the influences of the alternate cycle,relative molecular mass and pre-slug of the polymer etc.on the gas deposit rate of the oil reservoirs and gas breakthrough velocity show that the gas channeling can be effectively slowed down via shortening the cycle of the alternating,medium-molecule-weight polymer alternation and even higher concentration polymer pre-slug.

关键词(KeyWords)： 天然气;聚合物;交替注入;驱油效果
natural gas;polymer;alternately injection/driving;oil displaced effect/result

Abstract:

Keywords:

基金项目(Foundation): 中国石油股份公司重大科技专项“大庆油田原油4000万吨持续稳产关键技术研究”支撑项目部分成果

作者(Author): 李俊
LI Jun

参考文献(References)：

• [1]张继成,梁文福,余兴华,等.喇嘛甸油田特高含水期老井的技术经济界限[J].大庆石油学院学报,2004,28(2):101.103.
• [2]宋考平,高群峰,甘晓飞,等.喇嘛甸油田特高含水期油井合理地层压力及流压界限[J].大庆石油学院学报,2004,28(2):98-100.
• [3]徐亚萍,穆文志,宋国光,等.喇嘛甸油田水驱开发注水量界限的实验[J].大庆石油学院学报,2005,29(3):26-30.
• [4]赵永胜,魏国章,陆会民,等.聚合物驱能否提高驱油效率的几点认识[J].石油学报,2001,22(3):43-46.
• [5]王志武.三次采油[M].北京:石油工业出版社,1995:85-88.
• [6]牛金刚.大庆油田聚合物驱提高采收率技术的实践与认识[J].大庆石油地质与开发,2004,23(5):91-93.
• [7]郭万奎,程杰成,廖广志.大庆油田三次采油技术研究现状及发展方向[J].大庆石油地质与开发,2002,21(3):1-6.
• [8]谢力.水气交替注入的油田经验回顾[J].国外石油动态,2001,4(13):9-21.
• [9]冯宝俊,高畅.水气交替注入试验效果分析[J].大庆石油地质与开发,1995,14(3),60-62.
• [10]杨寿山.水气交替注人提高原油采收率矿场经验评述[J].国外油气地质信息,2002,87(2):102-108.
• [11]张思富,贾忠盛,杜兴家,等.大庆油田注天然气非混相驱矿场试验研究[J].油气采收率技术,1998,5(4):31-35.
• [12]贾忠盛,潘严富,王滨玉.大庆油田烃气非混相驱矿场试验[J].石油勘探与开发,1997,24(1):39-41.
• [13]杨浩,肖平,胡春礼,等.气驱窜流特性理论研究[J].大庆石油地质与开发,2010,29(4):156-159.
• [14]操自强,李睿姗,黎瑶.聚合物与水气交替联驱提高采收率试验研究[J].江汉石油职工大学学报,2007,20(4):41-44.
• [15]丁名臣,岳湘安,汪杰,等.不同非均质性模型中注气方式对气驱油的影响[J].科学技术与工程,2013,13(27):8126-8129.
• [16]乔红军,任晓娟,闫凤平,等.低渗透储层水气交替注入方式室内试验研究[J].石油天然气学报,2013,35(7):114-117.